Technical Advice

Swimming Pool Season Start Clean-up Procedure

Before the “SetUp” chemicals are added and the “Aquatick√” system is used the water must be clean and the pool clear of all debris.

If the water is not clean then follow the procedures set out below.

The methods set out here should clear up the vast majority of cases. The other most likely difficulty you will encounter is that the water will not filter clear.

Clarify water by flocculating with PAC from our Industrial Product range.

NOTE: THE CLEAR TEST - Can you easily see a 50 cent coin on the bottom at the deep end? If not, the water is not clear! There is no point in sending a sample for analysis until the water is clean. During the clean up process there is often a lot of water lost so a lot of the set up chemicals would also be lost.